How To Flash Adopisoft LAN SUBVENDO

 Download Firmware here:

LAN Subvendo (Arduino Nano): https://drive.google.com/drive/u/2/folders/1uxheUQGGOaJ2axiYu4LIWff3LSnlqTna

(added support for any captive portal ip other than 10.0.0.1)

(Fixes for disconnection issues)

  2 types of firmware for arduino nano:

  (ado-lan-subvendo-arduino) for builds with SET pin as coin acceptor enabler/blocker

  (ado-lan-subvendo-arduino-no-fast-blocking) for builds with power cut as coin acceptor enabler/blocker

Download Xloader here:
https://drive.google.com/file/d/1f30m70XrunIsNUQmuhMdlj4I8seXtH11/view?usp=sharing

Instructions:

1. Install XLoader
2. Download Arduino Hex. 

Connect your arduino to PC and determine the COM Port.

Open Xloader. Select the hex file you downloaded (ado-lan-subvendo-arduino.hex or ado-lan-subvendo-arduino-no-fast-blocking.hex for powecut setup). Set proper Device and COM PORT. Set Baud rate: as is.Use the recommended baud rate set by Xloader .In short "do not change" Then click Upload.
If hanged-unplug arduino from PC then plug again then select the next available model type.Repeat the process to every model until:
If failed, it means ok. Failed means successful flash.

To test, if the reading of P5 and P10 is P1.00. it means you have a powercut setup and you flash it with the wrong hex file.It means you need to reflash using ado-lan-subvendo-arduino-no-fast-blocking.hex.